Construction Details The luminaire consists of a high-pressure die-cast aluminium (EN 1706 AC-44300) base and eyelid trim ring and clear prismatic or opal high-impact acrylic diffuser. It is designed to operate LEDs of 1370lm (9W).
SABS Marks The luminaire bears the SANS 60598-2-1 safety mark.
Ingress Protection IP 65 in compliance with SANS 60598-2-1: The IP rating is certified by an SABS test report.
Base All base castings are manufactured from high-pressure die-cast aluminium, finished both outside and inside in white epoxy powder coating for added protection and reflectivity. It is simple to install due to four mounting holes provided outside the lamp compartment through lugs that form part of the base casting. The incorporated reflector is manufactured from 99.98% super pure deep anodized aluminium for optimal downward light output. The trim ring casting is mounted onto the base casting by stainless steel M5 Allen head screws, located outside the lamp compartment. The fixing holes can be supplied with stainless steel helicoil inserts on request.
Diffuser A clear prismatic or opal non-discolouring high-impact acrylic injection moulded diffuser is used throughout the range. It offers excellent vandal resistance, is highly translucent and will not discolour even when subjected to the harshest UV environments. A silicon sponge gasket is fitted into a special groove in the diffuser to prevent damage to the gasket during installation.
It fits snugly over a tongue provided on the base casting, thus achieving the certified ingress protection rating of IP 65.
Trim Ring The eyelid trim ring casting is manufactured from high- pressure die-cast aluminium and is finished in a special multi-stage epoxy powder surface coating.
Electrical Components The electronic control gear is mounted directly onto the base casting. It is suitable for operation with the specified rating of the lamp on a 230V ±10% 50Hz single phase system. The luminaire is supplied with a 300mm supply lead. All external screws, bolts and metals are stainless steel or of non-corrosive material. Mains connections are by means of a suitable screw terminal block with a wire clamping contact. The luminaire is power factor corrected to ≥0,9.
Dimensions in mm
Four fixing holes to hold the trim ring casting to the base casting
by stainless steel M5 Allen head screws, located outside the lamp
Base casting is manufactured from high-pressure die-cast aluminium, finished both outside and inside in white epoxy powder coating for added protection and reflectivity.
Tongue provided on the base casting fits into the silicon sponge gasket seated in the diffuser, thus achieving SABS certified IP 65 protection.
Four mounting holes provided outside the lamp compartment ensure the integrity of the certified IP rating. The mounting holes are raised
2mm from the base, preventing rainwater from running over the luminaire surface, and are also offset from the main axis in order to
prevent accidental damage to conduits during the installation process.
99.98% super pure deep anodized aluminium reflector.
The grommet provided in the base casting allows the
feeding through of the Teflon® wiring supplied, thus ensuring integrity of
IP 65 rating.
It is designed to operate LEDs of up to 9W.