Your browser is not up to date and is not able to run this publication.
Learn more

SABS Marks The luminaire bears the SANS 475 performance mark and the SANS 60598-2-5 safety mark.

Ingress Protection IP 65 in compliance with SANS 60598-2-5. The IP rating is certified by a SABS test report.

Luminaire Housing The housing is robustly constructed, weatherproof, hail proof, corrosion proof and vandal resistant. It is manufactured from die cast aluminium (EN 1706 AC-44300). The front glass covering the lamp compartment is heat and impact resistant, held to the lamp housing by stainless steel clamps and sealed by an extruded heat resistant silicon gasket. Helicoils are inserted for the attachment of the lamp housing and the gear compartment to prevent the galvanic corrosion of stainless steel screws to the aluminium housing.

Reflector System The reflector system is manufactured from 99,98% super-pure anodized aluminium and consists of the back reflector and two side reflectors. The luminaire is available in an asymmetrical narrow, medium and wide beam distribution.

Lampholder Housing Lamp replacement is facilitated from the side by a high-pressure die cast aluminium lampholder housing. It is sealed with a one-piece silicon gasket and is held to the floodlight with two stainless steel screws.

Control Gear Compartment The control gear compartment is manufactured from high pressure die cast aluminium for good heat dissipation. It consists of a lid and body that seals the control gear compartment to an IP 65 ingress protection rating when closed. The control gear compartment is attached to the stirrup.

Options Aiming device available on request, in order to set the floodlight to the desired aiming angle.

Electrical Components The lamp holder complies with VC 8011, is rated to withstand 240˚C/5kV. The control gear is incorporated inside the control gear compartment and is mounted on a removable gear tray. It is suitable for operation up to 1000W on a 230V +3%/-10% 50Hz single phase system. All control gear components are removable and bear the relevant SABS mark. All screws, bolts and metal parts are stainless steel or anti-corrosion treated material. Mains connections are by means of a suitable screw terminal block with wire clamping contact. Ignitors, where applicable, are of the superposed pulse type. The luminaire is power factor corrected to a minimum of 0,9. Tapped control gear is available on request.

Stirrup The stirrup is manufactured from hot dipped galvanized steel. Holes are provided for mounting purposes. A stainless steel version is available on request.

Dimensions in mm

PRL 600W/1000W

26 1

82

120

383

545

495

22 0

Aerodynamic resistance: 0.28m2

190

460

ø19 ø19

PRL 400W

25 9

152

376

27 4

50

15 3

156

376

96 96

ø13

421

357

Aerodynamic resistance: 0.18m2

Construction Details The luminaire consists of a die cast aluminium (EN 1706 AC-44300) housing with a separate but attached gearbox designed to operate 400/600/1000W high pressure sodium and 400/1000W metal halide tubular lamps.

416 417