83

83BEKASTRADA

Gear compartment

manufactured from

high-pressure die-cast

aluminium to ensure

excellent heat dissipation

and optimum strength

Porcelain GES

lampholder mounted on

aluminium bosses

Silicone sponge gasket

in a tongue-and-groove

arrangement, achieving

IP 66 ingress protection

Housing material

of filled,

ultra-violet stabilised

engineering polymer

V-shaped

back-reflector

to optimise

efficiency

Front clip hinges

diffuser for ease

of maintenance

Suitable for a large

range of lamp

source up to 400W

Optional down facing

miniature daylight

switch, protected

against UV

Side entry

spigot -

ø42mm x 125mm

Screw terminal block

and mains incoming wire

clamp.

Large stainless steel clips,

ensuring easy access and

evenly distributed closing

pressure

99.98% super pure deep

anodised aluminium reflector

system to meet requirements

of SANS 10098

Gear compartment rated IP 66 offering the

ultimate solution to corrosion problems and

premature failure of control gear components

and is suitable for operation with the specified rating

of the lamp on a 230V +3%/-10% 50Hz single phase

system.

All control gear components are removable. Ignitors,

where applicable, are of the superposed pulse type.

The luminaire is power factor corrected to a minimum

of 0,9.

SPIGOT COMPARTMENT The separate spigot compartment houses the screw

terminal block and wire clamp.

No access to the control gear compartment is required

for installation, thus possible damage to the control

gear is avoided.

An optional down facing miniature daylight switch can

be fitted into this compartment, giving it protection

against UV and ensuring extended service.