ingress of dust and moisture, which leads to corrosion
and premature failure.
The control gear is mounted on a removable gear tray
and is suitable for operation with the specified rating
of the lamp on a 230V +3%/-10% 50Hz single phase
All screws, bolts and metal parts are stainless steel or
anti-corrosion treated material.
Ignitors, where applicable, are of the superposed pulse
The luminaire is power factor corrected to a minimum
SPIGOT COMPARTMENT The separate spigot compartment houses the screw
terminal block and wire clamp. No access to the control
gear compartment is required for installation, thus
possible damage to the control gear is avoided. An
optional downfacing miniature daylight switch can be
fitted into this compartment, giving it protection against
UV and ensuring extended service.
Hinged, non-corrosive lid, which
fits into a silicon sponge gasket
in the housing, in a tongue and
Gear compartment rated IP 66,
offering the ultimate solution to
corrosion problems and premature
failure of control gear components.
Robust hinge mechanism, incorporated
into the housing, ensures protection
against damage during transport,
installation and maintenance.
rated IP 66.
Interior lip to protect
gasket against harmful
radiation from the lamp
Exterior lip on lamp
housing to avoid direct
rainwater contact with
the gasket, ensuring that no
moisture is sucked into
the diffuser when the
luminaire is switched off
and cools down.
Suitable for lamps up to 150W.
Optional integrally mounted MCB
5A/2.5kA, accessible from the outside.
Optional down facing miniature
daylight switch, protected against UV.
ensures that the
control gear is not subjected
to possible damage during
installation or by moisture rising
up a pole when heated by the sun
during the day.
Screw terminal block
and mains incoming